Skip to content
OBSCUUR

How to make a house track that DJs actually play

How to make a house track that DJs actually play

A house track that DJs play is built for the mix first and the listener second. It has a clear intro and outro, a fixed tempo, a kick and bassline that share the low end, and an arrangement that moves every eight or sixteen bars. Get those four things right and the rest is taste.

What makes a house track easy for DJs to play?

A DJ has seconds to decide whether a track fits the moment. If it blends cleanly and does something useful in a set, it gets played again. If it fights the mix, it stays in the crate.

Start with tempo. House mostly lives between 120 and 130 BPM. Pick one tempo and hold it for the whole track. Tempo drifts, tempo changes and loose timing all make beatmatching harder, and a DJ will not fix your track for you.

Next, think in phrases. Dance music runs in blocks of eight, sixteen and thirty-two bars. Keep your changes on those boundaries: a new element, a breakdown, a drop. When your sections land on the phrase, a DJ can predict where the track is going and plan the next mix around it.

How long should the intro and outro be?

Long enough to mix in and out of. A common approach is 16 to 32 bars at each end, built mostly from drums and percussion with little melody or harmony. That gives the DJ room to bring your track in under the previous one without two sets of chords clashing.

Keep the intro and outro simple on purpose. A drum-led start is easy to blend. A busy melodic start limits where your track can go in a set. You can still put a hook early, but do not let it crowd out the groove.

A useful test is to open two tracks in a DJ app, or on real decks, and mix yours in over something else. If the blend feels awkward, the intro is doing too much.

How do you get the low end right for a club system?

The kick and the bass compete for the same space, and this is where many tracks fall apart. Decide which one owns the lowest frequencies at each moment, and shape the other around it. Sidechain compression on the bass is the usual tool. Careful EQ does the same job.

A few habits help:

  • High-pass the elements that do not need low end, such as hats, pads and vocals.
  • Keep the sub bass mono.
  • Leave headroom on the master. A track mastered flat against the ceiling gives the DJ nothing to work with and can distort on a big system.
  • Compare your mix with finished releases at the same loudness, on speakers you know.

Reference tracks matter here. Load a few released records into your project and switch between them and your mix. OBSCUUR releases such as Shugz – Keys To The Rave (2026), Four To Eight – Rave Prescription (2026) and Prinsezy – Sexy Garage (2025) are the kind of finished, label-ready records you can set beside your own. You can find more on the artists page.

What should you check before you send it to a label?

Run through a short list before you export.

  • Mix it yourself. Blend the track between two others. Note where you reach for the EQ or where the groove falls over.
  • Check the ends. Make sure the intro and outro are clean, with no stray tails, clicks or cut-off reverb.
  • Check the structure. Count the bars. Every change should land on a phrase.
  • Export properly. Send a full-quality WAV with headroom, not a clipped master or a low-bitrate file.
  • Name your files. Use a clear title and artist name so nothing gets lost.

Then listen on more than one system. Headphones, a laptop and a car stereo each expose different problems. If the kick and bass hold up on all of them, you are close.

When the track is ready, send it through the submissions page. Keep the pitch short and the file clean.

Build it for the mix, and the DJs will find a place for it.

Read next

More →